Toro GrandStand Series - Page 276

HYDRAULIC DRIVE SYSTEM
6-17Toro GrandStand Service Manual
6
A. Lift rod B. Brake rod
35. Lift the tower assembly up off the frame and lay it
back as shown, taking care that the lift bar is routed
out from under the right hand lift cylinder and the
brake rod is routed out from under the control panel
(Fig. 0960).
Fig. 0960 IMG-9352a
36. Remove the cable tie securing the wire harness and
2 low pressure hydraulic hoses (Fig. 0961).
Fig. 0961 IMG-9354a
37. 2009 only: Remove the hairpin cotter and washer
from the front end of the left hand shifter link rod
(Fig. 0962).
Fig. 0962 IMG-9358a
A
B
38. 2010 only: Remove the bolt, nut, washers and
spacer securing the LH shifter link to the shifter
bracket (Fig. 0963).
Fig. 0963 IMG-0904a