Toro GrandStand Series - Page 278

HYDRAULIC DRIVE SYSTEM
6-19Toro GrandStand Service Manual
6
43. Serial range 290000210 - 290999999: Push down
on the control fork assembly and remove the center
roller from the pump control arm slot (Fig. 0968).
Fig. 0968 IMG-9371a
Shifter Link and Roller Congurations (Fig. 0970):
A. 2009: Serial range 290000001-290000210;
3 rollers, all thin and same size
B. 2009: Serial range 290000211-290999999;
3 rollers, large center roller
C. 2010: Serial range 310000001-310999999;
3 rollers, all large and same size
Fig. 0970 IMG-0941a
A
B
C
45. Mark the hydraulic pump, ttings and lines (Fig.
0971):
1) Charge line
2) Return line
3) High pressure hose
4) High pressure hose
Fig. 0971 IMG-9378a
44. 2010 only: Remove the LH shifter link and the 3
rollers located on the rear end of the shifter link
inside of the control fork assembly (Fig. 0969).
Fig. 0969 IMG-0936a