Toro GrandStand Series - Page 283

HYDRAULIC DRIVE SYSTEM
6-24 Toro GrandStand Service Manual
6
8. Serial range 290000210 - 290999999: Slide the
right hand roller onto the rear end of the left hand
shifter link rod. Slide the rear end of the shifter link
rod (with roller) through the control fork assembly
following the Allen wrench through to capture the
center roller on the shifter link rod (Fig. 0989).
Fig. 0989 IMG-9407a
9. Serial range 290000210 - 290999999: Slide the left
hand roller onto the rear end of the left hand shifter
link rod and into the outside of the control fork as-
sembly (Fig. 0990).
Fig. 0990 IMG-9410
6. Serial range 290000210 - 290999999: Push down
on the control fork assembly and slide the center
roller into the slot of the pump control arm (Fig.
0987).
Fig. 0987 IMG-9400
7. Serial range 290000210 - 290999999: Using an
Allen wrench as a pilot, locate the center roller and
slide the Allen wrench through it (Fig. 0988).
Fig. 0988 IMG-9405