HYDRAULIC DRIVE SYSTEM
6-25Toro GrandStand Service Manual
6
10. 2010 only: Slide 3 rollers onto the rear end of the
left hand shifter link. Slide the rear end of the shifter
link (with three rollers) into the control fork assembly
(Fig. 0991).
Fig. 0991 IMG-0936a
13. 2010 only: Place a spacer into the front end of the
shifter link (Fig. 0994).
Fig. 0994 IMG-0946a
11. Slide a washer onto the rear end of the shifter link
rod. Install a hairpin cotter to secure (Fig. 0992).
Fig. 0992 IMG-9361a
12. 2009 only: Slide the front end of the left hand
shifter link rod into the left side of the dual shifter
arm. Slide a washer onto the front end of the shifter
link rod. Install a hairpin to secure (Fig. 0993).
Fig. 0993 IMG-9415a
To Next Page
Loading...
