HYDRAULIC DRIVE SYSTEM
6-27Toro GrandStand Service Manual
6
18. Position the choke cable R-clamp onto the self-
tapping screw located on the left hand rear corner
where the tower meets the main frame. Install a nut
to secure (Fig. 0999).
20. Install 3 push cable ties through the holes located in
the base of the tower (Fig. 1001).
Fig. 0999 PICT-8609a
19. Install 3 nuts to the remaining 3 self-tapping screws
securing the tower to the frame (Fig. 1000).
Fig. 1000 IMG-9338a
Fig. 1001 IMG-9524a
To Next Page
Loading...
