HYDRAULIC DRIVE SYSTEM
6-34 Toro GrandStand Service Manual
6
47. Slide the left pump pulley onto the pump shaft (Fig.
1025).
Fig. 1025 IMG-9464a
48. Install the 2 left pump pulley set screws (Fig. 1026).
Fig. 1026 IMG-9471a
49. Route the pump belt around the pump pulleys (Fig.
1027).
Fig. 1027 IMG-9543a
50. Using a spring tool (Toro Part No. 92-5771), install
the pump idler extension spring (Fig. 1028).
Note: 2010 machines have the end of the extension
spring connected to an anchor, not the back
side of the engine base.
Fig. 1028 IMG-9545a
To Next Page
Loading...
