CHASSIS
3-9Toro GrandStand Service Manual
3
19. Secure the yoke on the lower end of the brake rod
to the brake assembly using a clevis pin and hairpin
cotter (Fig. 0030).
21. If adjustment is needed, remove the clevis pin secur-
ing the yoke to the brake arm. Rotate the yoke to
obtain the desired gap (Fig. 0032).
Fig. 0030 DSCN-0264a
20. The brake assembly should contact the tires when
there is approximately 3/4” (1.9cm) gap between
the front edge of the control panel slot and the front
edge of the brake lever (Fig. 0031).
A. 3/4” (1.9cm)
Fig. 0031 DSCN-0263a
Fig. 0032 DSCN-0264a
A
To Next Page
Loading...
