Toro GrandStand Series - Page 304

HYDRAULIC DRIVE SYSTEM
6-45Toro GrandStand Service Manual
6
41. Serial range 290000210 - 290999999: There are
3 rollers located on the rear end of the right hand
shifter link rod inside the control fork assembly and
pump control arm. Slide the left hand roller off the
rear end of the right hand shifter link rod (Fig. 1065).
Fig. 1065 IMG-9430a
43. Serial range 290000210 - 290999999: Push down
on the control fork assembly and remove the center
roller from the pump control arm slot (Fig. 1067).
Fig. 1067 IMG-9436a
42. Serial range 290000210 - 290999999: Remove the
rear end of the right hand shifter link rod and the
right hand roller (Fig. 1066).
Fig. 1066 IMG-9432a
44. 2010 only: Remove the RH shifter link and the
3 rollers located on the rear end of the shifter link
inside of the control fork assembly (Fig. 1068).
Fig. 1068 IMG-0948a