HYDRAULIC DRIVE SYSTEM
6-48 Toro GrandStand Service Manual
6
Right Hydraulic Pump Installation
1. Position the Pump Control Arm to the pump linkage
and install 2 bolts and nuts to secure (Fig. 1078).
Fig. 1078 IMG-9391a
2. Position the right hand pump into the frame. Align
the mounting ange on the pump with the mounting
holes in the frame (Fig. 1079).
Fig. 1079 IMG-9483a
52. If you are servicing the pump, refer to the Hydro-
Gear P Series Hydrostatic Pumps Service and
Repair Manual (Form No. BLN 52503).
53. If you are installing a new pump, transfer all mark-
ings and all 4 ttings to the new pump (Fig. 1077).
Fig. 1077 PICT-8870a
To Next Page
Loading...
