Toro GrandStand Series - Page 309

HYDRAULIC DRIVE SYSTEM
6-50 Toro GrandStand Service Manual
6
6. Serial range 290000210 - 290999999: Push down
on the control fork assembly and slide the center
roller into the slot of the pump control arm (Fig.
1086).
Fig. 1086 IMG-9437a
7. Serial range 290000210 - 290999999: Using an
Allen wrench as a pilot, locate the center roller and
slide the Allen wrench through it (Fig. 1087).
Fig. 1087 IMG-9492a
Shifter Link and Roller Congurations (Fig. 1084):
A. 2009: Serial range 290000001-290000210;
3 rollers, all thin and same size
B. 2009: Serial range 290000211-290999999;
3 rollers, large center roller
C. 2010: Serial range 310000001-310999999;
3 rollers, all large and same size
Fig. 1084 IMG-0941a
A
B
C
5. Serial range 290000001 - 290000209: Slide 3
rollers onto the rear end of the right hand shifter link
rod. Slide the rear end of the shifter link rod (with 3
rollers) into the control fork assembly (Fig. 1085).
Fig. 1085 IMG-9486a