HYDRAULIC DRIVE SYSTEM
6-52 Toro GrandStand Service Manual
6
14. 2010 only: Secure the shifter link to the shifter
bracket with a bolt two washers and nut (Fig. 1094).
Fig. 1094 IMG-0905a
15. Install a cable tie securing the wire harness and 2
low pressure hydraulic hoses (Fig. 1095).
Fig. 1095 IMG-9501a
13. 2010 only: Place a spacer into the front end of the
shifter link (Fig. 1093).
Fig. 1093 IMG-0946a
12. 2009 only: Slide the front end of the right hand
shifter link rod into the left side of the dual shifter
arm. Slide a washer onto the front end of the shifter
link rod. Install a hairpin to secure (Fig. 1092).
Fig. 1092 IMG-9423a
To Next Page
Loading...
