HYDRAULIC DRIVE SYSTEM
6-53Toro GrandStand Service Manual
6
16. Lift the tower assembly up and lower it onto the
frame, taking care that the lift bar is routed between
the right hand lift cylinder and the RH Lift Rod
assembly. Also ensure the top end of the brake rod
is routed under the control panel and up to the brake
handle lever (Fig. 1096).
Fig. 1096 IMG-9513a
17. Align the tower and frame mounting holes. Install 4
self-tapping screws to secure the tower to the frame
(Fig. 1097).
Fig. 1097 IMG-9516a
18. Position the choke cable R-clamp onto the self-
tapping screw located on the left hand rear corner
where the tower meets the main frame. Install a nut
to secure (Fig. 1098).
Fig. 1098 PICT-8609a
19. Install 3 nuts to the remaining 3 self-tapping screws
securing the tower to the frame (Fig. 1099).
Fig. 1099 IMG-9338a
To Next Page
Loading...
