CHASSIS
3-12 Toro GrandStand Service Manual
3
HOC Handle Assembly Installation
9. Move the HOC handle assembly from its frame
mount; then remove the lift bar pivot hub (Fig. 0041).
1. Install the plastic bushing into the upper end of the
lift bar (Fig. 0043).
Fig. 0041 DSCN-0292a
10. Remove the lift bar by lowering it down through the
fuel tank base.
11. Remove the HOC handle assembly from the control
tower.
12. Remove the plastic bushing from the upper end of
the lift bar (Fig. 0042).
Fig. 0042 DSCN-0297a
Fig. 0043 DSCN-0297a
To Next Page
Loading...
