Toro GrandStand Series - Page 339

HYDRAULIC DRIVE SYSTEM
6-80 Toro GrandStand Service Manual
6
3. Orient the tting so it is pointing straight rearward.
Secure the position with the tting jam nut (Fig.
1194).
Fig. 1194 IMG-0886a
4. Install the 45 degree tting into the base of the
reservoir (Fig. 1195).
Fig. 1195 IMG-0887a
5. Orient the tting so it is at a 1 o’clock position. Se-
cure the position with the tting jam nut (Fig. 1196).
Fig. 1196 IMG-0888a
6. Install the low pressure suction line to the 90 degree
tting and secure with hose clamp (Fig. 1197).
Fig. 1197 IMG-0889a