CHASSIS
3-13Toro GrandStand Service Manual
3
2. Position the lift bar up through the slot in the fuel
tank base, to the approximate mounting location Fig.
0044).
Fig. 0044 DSCN-0307a
3. Install the lift arm pivot hub into the HOC handle
assembly (Fig. 0046).
Note: Do not install the “E” clip. It will be installed
in a later step.
Fig. 0046 DSCN-0303a
4. Position the HOC handle assembly in the control
tower, just above its mounting bracket. Install the lift
bar onto the pivot hub (Fig. 0047).
Fig. 0047 DSCN-0291a
Note: 2010 only: The tube welded to the base of the
lift bar must face to the right (Fig. 0045).
Fig. 0045 DSCN-0304a
To Next Page
Loading...
