Toro GrandStand Series - Page 340

HYDRAULIC DRIVE SYSTEM
6-81Toro GrandStand Service Manual
6
7. Position the reservoir into the reservoir bracket.
While lowering the reservoir into place, install the
low pressure hose onto the lter mount bracket
tting (Fig. 1198).
Fig. 1198 IMG-0836a
8. Secure the hose to the tting with the hose clamp
(Fig. 1199).
Fig. 1199 IMG-0832a
10. Secure the reservoir assembly to the reservoir
bracket using two sets of screws, washers and nuts
(Fig. 1201).
9. Position the two spacers between the reservoir
mounting surface and the reservoir bracket (Fig.
1200).
Fig. 1200 IMG-0891a
Fig. 1201 IMG-0834a