CHASSIS
3-14 Toro GrandStand Service Manual
3
7. Place the two HOC bracket bolts through the side
of the control panel. The carriage bolt goes into the
upper hole (Fig. 0050).
Fig. 0050 DSCN-0323a
6. Secure the HOC handle assembly to the control
tower using the carriage bolt and nut (Fig. 0049).
Note: Do not over-tighten. The HOC handle assem-
bly must move freely.
Fig. 0049 DSCN-0288a
8. Place a spacer over each of the bolts (Fig. 0051).
Fig. 0051 DSCN-0325a
5. Secure the pivot hub with the “E” clip (Fig. 0048).
Fig. 0048 DSCN-0285a
To Next Page
Loading...
