Toro GrandStand Series - Page 353

HYDRAULIC DRIVE SYSTEM
6-94 Toro GrandStand Service Manual
6
17. After all necessary repairs have been made, re-
connect the hydraulic hoses to the wheel motor
ttings.
18. Slide the wheel and tire assembly onto the hub and
snug t the 4 lug nuts on the wheel hub studs.
19. Lower the machine so the rear tires are resting on
the ground.
20. Apply the parking brake.
21. Tighten and torque the 4 lug nuts to 85 + 8 ft-lbs.
(115 + 10.8 Nm) (Fig. 1242).
23. Release the parking brake.
24. Bleed the hydraulic system. See “Bleeding the
Hydraulic System” on page 6-95.
25. Test operate machine and adjust tracking and
neutral as needed.
22. Fill the reservoir with hydraulic uid as specied.
Note that there are ll level lines inside of the
reservoir (Fig. 1243).
Fig. 1242 IMG-0029a
Fig. 1243 g. 68 G001045
A. Cap C. Cold uid level-full
B. Bafe D. Hot uid level-full
A
B
D
C