Toro GrandStand Series - Page 373

MOWER DECK
7-18 Toro GrandStand Service Manual
7
16. Press a new bearing into one end of the spindle
housing hub (Fig. 1305).
Fig. 1305 IMG-9804a
17. Turn the spindle housing over and slide a bearing
spacer into the spindle hub (Fig. 1306).
Fig. 1306 IMG-9807a
18. Press a new bearing into the end of the spindle
housing hub (Fig. 1307).
Fig. 1307 IMG-9809a
19. Slide the bearing shield onto the spindle shaft (Fig.
1308).
Fig. 1308 IMG-9796a