Toro GrandStand Series - Page 375

MOWER DECK
7-20 Toro GrandStand Service Manual
7
24. Insert the square key into the spindle shaft keyway
(Fig. 1313).
Fig. 1313 IMG-9792a
25. Slide the pulley hub onto the end of the spindle shaft
(hub side up) aligning it with the square key (Fig.
1314).
Fig. 1314 IMG-9791a
26. Slide the washer onto the end of the spindle shaft
(Fig. 1315).
Fig. 1315 IMG-9790a
27. Install the hex nut onto the end of the spindle shaft
and torque to 100 + 10 ft-lbs. (135.5 + 13.5 Nm)
(Fig. 1316).
Fig. 1316 IMG-9814a