Toro GrandStand Series - Page 377

MOWER DECK
7-22 Toro GrandStand Service Manual
7
Spring Idler Installation
5. Remove the two plain washers, two friction compo-
site washers, and bushing (Fig. 1320).
A. Plain washer (2) C. Bushing
B. Friction composite
washer (2)
A. Nut D. Idler Plate
B. Idler Pulley E. Carriage Bolt
C. Washer (2)
1. Install the carriage bolt, nut, and washers securing
the pulley (hub down) to the idler plate (Fig. 1322).
A. Nut D. Idler plate
B. Idler pulley E. Carriage bolt
C. Washer (2)
Fig. 1320 IMG-0601a
6. Remove the carriage bolt, nut, and washers securing
the pulley to the idler plate (Fig. 1321).
Fig. 1321 IMG-0603a
Fig. 1322 IMG-0603a
2. Place the carriage bolt up through the mower deck
and install a plain washer and bushing (Fig. 1323).
Fig. 1323 IMG-0621a
A
B
C
D
E
A
B
C
D
E
A
B
B
C
A