Toro GrandStand Series - Page 379

MOWER DECK
7-24 Toro GrandStand Service Manual
7
Adjustment Idler Installation
4. Remove the idler adjust assembly from the mower
deck (Fig. 1328).
1. Install the carriage bolt, nut, and washers securing
the pulley (hub down) to the idler plate (Fig. 1330).
A. Nut D. Idler Plate
B. Idler Pulley E. Carriage Bolt
C. Washer (2)
A. Nut D. Idler Plate
B. Idler Pulley E. Carriage Bolt
C. Washer (2)
Fig. 1328 IMG-0608a
5. Remove the carriage bolt, nut, and washers securing
the pulley to the idler plate (Fig. 1329).
Fig. 1329 IMG-0609a
Fig. 1330 IMG-0609a
2. Place the carriage bolt up through the mower and
install a spacer (Fig. 1331).
Fig. 1331 IMG-0612a
A
B
C
D
E
A
B
C
D
E