Toro GrandStand Series - Matching Height-of-Cut

MOWER DECK
7-53Toro GrandStand Service Manual
7
Matching Height-of-Cut
6. Adjust the adjustment bolt until the blade tips match
3” (7.6cm) (Fig. 1428).
1. Check the rear tire pressure.
2. Set the height-of-cut to the 3” (7.6cm) position.
3. With the machine on level surface, position one
blade front-to-rear. Measure at A and from level sur-
face to the cutting edge of the blade tips (Fig. 1427).
4. The measurement should be 3” (7.6cm).
5. If it does not measure correctly, locate the height-of-
cut rod on the right side of the machine (Fig. 1428).
Fig. 1427 g. 87 G000975
Fig. 1428 g. 88 G013167
1. Measure from a level surface
2. Measure blad at point A
1. Height-of-cut rod 2. Adjustment bolt
1
2
1
2