Toro GrandStand Series - Page 440

ELECTRICAL
8-31Toro GrandStand Service Manual
8
32. Lower the mower deck to the lowest height-of-cut
(Fig. 1524).
34. Using a ratchet in the idler arm, tension the arm until
the spring is stretched 5-3/4” (14.6cm) hook to hook
and then tighten the nut (Fig. 1526).
Fig. 1524 IMG-9676a
33. Route the mower deck belt around the mower deck
pulleys and clutch pulley. Refer to the belt routing
decal (Fig. 1525):
Fig. 1525 117-0486a
Fig. 1526 g. 61 G009460
A. 5-3/4” (14.6cm) D. Ratchet
from hook to hook E. Square hole for ratchet
B. Spring F. Nut
C. Spring loaded idler
A
B C
D
E
F