Toro GrandStand Series - Page 62

CHASSIS
3-41Toro GrandStand Service Manual
3
7. Repeat steps 4 through 6 on the other side if re-
placing both gas spring assemblies.
8. Loosen the lower lock nut on the lift bar 1/2 turn (Fig.
0151 and Fig. 0152).
9. Spin the upper nut approximately 1/2” (1.27cm) up
the lift bar (Fig. 0153).
Fig. 0151 IMG-9705a
Fig. 0152 IMG-0088a
Fig. 0153 IMG-9749a
10. Tighten the lower nut on the lift bar until the com-
pression force on the gas spring assembly has been
relieved and the gas spring assembly can easily be
removed from the ball stud (Fig. 0154).
Fig. 0154 IMG-9709a