Seal Protector (Fig. 7)
Slide the protector (Item 1) over the reel motor shaft
before installing the shaft seal to protect the seal from
damage. Apply a light coating of clean oil to the seal
protector to ease movement of the seal over the tools.
Use the installer (Item 2) and a small hammer to drive
the reel motor shaft seal into position in the bore of the
reel motor body.
Figure 7
Detent Installation Tool (Fig. 8)
Use this tool with a 3/8 in. drive torque wrench to tighten
the detent stud in the No. 1 spool of the control valve.
Apply Loctite 222 or equivalent to the threads of the
detent stud. Tighten the stud to a torque of 10 - 14 ft-lb.
Figure 8
Special Tools Page 4 - 14 Greensmaster
®
3100
To Next Page
Loading...
