Toro Greensmaster 3150 Series - Adjusting Cutting Unit Components; Adjusting the Rear-Roller Height

g028838
Figure14
Models03639and03641
1.1.3mm(0.050inch)
2.30degrees
2.Spingrindthereeltoachieve<0.025mm(0.001
inch)reelrun-out.
Note:Thiscausesthelandwidthtogrow
slightly.
Note:T oextendthelongevityofthesharpnessofthe
edgeofthereelandthebedknife—aftergrindingthe
reeland/orthebedknife—checkthereeltobedknife
contactagainaftercutting2fairways,asanyburrs
willberemoved,whichmaycreateimproperreelto
bedknifeclearanceandthusacceleratewear.
AdjustingtheRear-Roller
Height
Dependingonyourdesiredheight-of-cutrange,you
needtoadjusttherear-rollerbrackets(Figure15or
Figure16)totheloworhighposition:
•Positionthespacerabovethesideplate-mounting
ange(factorysetting)whentheheight-of-cut
settingsrangefrom1.5mmto6mm(1/16inchto
1/4inch)asshowninFigure15.
g014404
Figure15
1.Spacer
3.Rollerbracket
2.Sideplate-mountingange
•Positionthespacerbelowthesideplate-mounting
angewhentheheight-of-cutsettingsrangefrom
3mmto25mm(1/8inchto1inch)asshownin
Figure16.
g014405
Figure16
1.Sideplate-mountingange
3.Rollerbracket
2.Spacer
1.Raisetherearofthecuttingunitandplacea
blockunderthebedknife.
2.Removethe2nutssecuringeachrollerbracket
andspacertoeachsideplatemountingange.
3.Lowertherollerandboltsfromthesideplate
mountingangesandspacers.
4.Placethespacersontotheboltsaboveorbelow
therollerbrackets,asrequired(Figure15or
Figure16).
5.Securetherollerbracketandspacerstothe
undersideofthemountingangeswiththenuts
previouslyremoved.
Note:Thepositionoftherearrollertothereel
iscontrolledbythemachiningtolerancesofthe
assembledcomponentsandparallelingisnot
required.
11