Toro Greensmaster 3150 Series - Adjusting the Height of Cut

AdjustingtheHeightofCut
Usethefollowingcharttodeterminewhichbedknifeis
bestsuitedforthedesiredheightofcut.
Bedknife
PartNo.
Height-of-Cut
Edgemax
Micro-cut
(Standard)
115-1880
1.5to4.7mm(0.062to
0.188inch)
Edgemax
Tournament
(Optional)
115-1881
3.1to12.7mm(0.125to
0.500inch)
Micro-cut
(Optional)
93-4262
1.5to4.7mm(0.062to
0.188inch)
Tournament
(Optional)
93-4263
3.1to12.7mm(0.125to
0.500inch)
Extended
Micro-cut
(Optional)
108-4303
1.5to4.7mm(0.062to
0.188inch)
Extended
Tournament
(Optional)
108-4302
3.1to12.7mm(0.125to
0.500inch)
Low-cut
(Optional)
93-4264
4.7to25.4mm(0.188to
1.00inch)
High-cut
(Optional)
94-6392
7.9to25.4mm(0.312to
1.00inch)
Fairway
(Optional)
63-8600
9.5to25.4mm(0.375to
1.00inch)
Fairway
EdgeMax
(optional)
112–7475
9.5to25.4mm(0.375to
1.00inch)
Note:Forheightsofcutgreaterthan9.5mm(0.375
inch),installthehigh-height-of-cutkit.
AdjustingtheHeight-of-CutGauge
Beforeadjustingtheheightofcut,settheheight-of-cut
gaugeasfollows:
1.Loosenthenutonthegaugebarandsetthe
adjustingbolttothedesiredheightofcut(Figure
17).
Note:Thedistancebetweenthebottomofthe
boltheadandthefaceofbaristheheightofcut.
g000489
Figure17
1.Gaugebar
3.Nut
2.Height-adjustingbolt
2.Tightenthenut.
AdjustingtheHeightofCut
1.Loosenthelocknutssecuringtheheight-of-cut
armstothecutting-unitsideplates(Figure18).
g020074
Figure18
1.Height-of-cutarm
3.Adjustingbolt
2.Locknut
2.Hooktheboltheadoftheheight-of-cutgauge
ontotherightsideofthecuttingedgeofthe
bedknifeandresttherearendofthebaronto
therearoftheroller(Figure19).
12