Toro Greensmaster Flex 1018 - Page 161

AssemblingtheRoller
g261670
Figure86
1.Roller4.Bearinglocknut
2.Ballbearing
5.Rollershaft
3.Seal
g261681
Figure87
1.Bearing3.Bearinglocknut
2.Seal
Note:Therearrollerisalowdragroller.
1.Pressthebearingintotheroller(supportbothinnerandouterraceways).
2.Placetherollershaftintotheroller.
3.Pressthe2ndbearingintotheroller(supportboth).
4.Installthesealingwasherandbearinglocknutontoeachendoftheroller
shaft.Tightenthelocknutsto34to41N∙m(25to30ft-lb).
InstallingtheFrontRoller
1.Placethecuttingunitonalevelworksurface.Useanappropriatesupportto
raisethefrontofthecuttingunitoffoftheworksurface.
2.Inspecttheconditionofbothheight-of-cutscrews(9)andreplacethemif
necessary.Applyanti-seizelubricanttothethreadsofanewheight-of-cut
screw(9).
Note:Wheninstallingtheheight-of-cutarms(5),makesurethatthetabofthe
sideplatetsbetweentheheadandthewasheroftheheight-of-cutscrew(9).
3.Secureoneoftheheight-of-cutarms(5)tothesideplatewithaplowbolt(1),
height-of-cutwasher(7)andlocknut(6).Thetabontheheight-of-cutwasher
shouldbeorienteddownwardandtintotheslotoftheheight-of-cutarm.
Greensmaster
®
Flex1018/1021
Page8–25
DPACuttingUnits:ServiceandRepairs
20247SLRevA