Greensmaster Flex 18/21 Page 7 – 5 Cutting Unit
Bearing and Seal Installer
Toro Part Number: TOR4105
Used to install bearings and seals into front and rear roll-
ers.
NOTE: TOR4105 is an alternative to using washers
and spacers listed above.
Figure 8
Sleeve Driver
Toro Part Number: TOR4107
Used to drive the wear sleeve into position on the cutting
reel shaft.
Figure 9
Sleeve Driver and Bearing and Seal Installer Set
Toro Part Number: TOR4108
Set includes both TOR4105 and TOR4107 in a plastic
storage case with foam inserts.
Figure 10
Cutting Unit
To Next Page
Loading...
