Greensmaster Flex 1800/1820/2100/2120Page 6 − 6Chassis and Controls
Throttle Cable Replacement
Removal
1. Park machine on a level surface. Make sure the en-
gine is OFF and the traction lever is in NEUTRAL.
2. Remove throttle cable from the engine governor link-
age (Fig. 4):
A. Loosen screw that secures cable clamp to engine
bracket. Remove cable from clamp.
B. Loosen screw that secures throttle cable to gov-
ernor lever. Slide cable from governor lever.
C. Separate throttle cable from engine.
3. Remove console cover from handle assembly to al-
low access to upper end of throttle cable.
4. Remove throttle cable from the throttle control as-
sembly (Fig. 5):
A. Remove retaining ring and flat washer that se-
cure throttle cable end to pin on throttle control. Slide
cable end from throttle control.
B. Remove the cable housing from the throttle
mount.
5. Remove throttle cable from the machine.
Installation
1. Connect throttle cable to throttle control assembly
(Fig. 5).
A. Secure throttle cable end to pin on throttle control
with flat washer and retaining ring.
B. Secure cable housing to throttle mount.
2. Route throttle cable to the engine. Make sure that
cable is routed on right side of throttle mount cable guide
(item 7 in Fig. 5).
3. Install cable to the engine governor linkage as fol-
lows (Fig. 4):
A. Slide throttle cable end into governor lever.
B. Place throttle cable under cable clamp.
C. Make sure throttle control is in the FAST position
and the governor lever is against the high speed
screw on governor linkage.
D. Tighten screw on cable clamp to secure the
throttle cable.
4. Check throttle cable adjustment (see Throttle Cable
Adjustment in the Adjustments section of Chapter 3 −
Engine).
5. Install console cover to handle assembly.
Figure 4
1. Throttle cable
2. Throttle cable clamp
3. Governor lever
4. High speed screw
3
2
1
4
1. Pin
2. Flat washer
3. Retaining ring
4. Throttle cable
5. Throttle control
6. Throttle mount
7. Mount cable guide
Figure 5
FRONT
RIGHT
6
5
1
2
3
4
7
To Next Page
Loading...
