Greensmaster Flex 1800/1820/2100/2120Page 7 − 4Cutting Unit
Separating Cutting Unit from Traction Unit
1. Position mower on a flat, level work surface. Make
sure engine is OFF. Remove spark plug wire from the
engine spark plug.
2. Lower the kickstand and push in the locking pin to
lock the kickstand in the service position (Fig. 2). Allow
the kickstand and machine to rest against the locking
pin.
3. Remove grass basket from cutting unit, if installed.
4. Slide the telescoping coupler off the cutting unit hex
shaft (Fig. 3).
5. Loosen two (2) flange head screws that secure cut-
ting unit pitch arms to traction unit roll frame (Fig. 4). It
is not necessary to completely remove the screws.
6. Rotate pitch arms forward and rest traction unit
against the kickstand.
7. Roll cutting unit away from machine.
8. Reverse procedure to install cutting unit to traction
unit.
9. After cutting unit is installed to traction unit, attach
spark plug wire to engine spark plug.
1. Kickstand 2. Locking pin
Figure 2
2
1
1. Telescoping coupler 2. Cutting unit hex shaft
Figure 3
2
1
1. Cutting unit pitch arm
2. Traction unit roll frame
3. Flange head screw
Figure 4
3
1
3
1
2
To Next Page
Loading...
