Greensmaster Flex 1800/1820/2100/2120 Belt Driven Groomer (Optional)Page 8 − 19
2. Install LH support plate to left side of cutting unit:
A. Apply antiseize lubricant to threads of LH groom-
er arm lift rod.
B. Position LH support plate to cutting unit making
sure that LH groomer arm lift rod is positioned
through bushing in support plate.
C. Place spring washer and lock nut on lift rod
threads (Fig. 19). Tighten lock nut.
D. Install reel drive assembly, reel pulley, reel drive
belt and then reel drive cover to left side of cutting
unit (see Reel Drive Assembly in the Service and Re-
pairs section of Chapter 4 − Traction and Reel Drive
System).
3. Install grooming reel, front roller and RH drive plate
to right side of cutting unit (see Grooming Reel (Forward
Rotating or Counter Rotating) in this section).
4. Check and adjust grooming reel height and mower
height−of−cut settings.
5. Install cutting unit to the machine.
6. Lubricate groomer bearings.
NOTE: After greasing groomer bearings, operate
groomer for 30 seconds, stop machine and wipe any ex-
cess grease from groomer shaft and seals.
1. RH drive plate assy
2. Bearing (2 used)
3. Seal (2 used)
Figure 21
3
1
2
2
3
Seal lips
(toward center of
cutting unit)
COUNTER ROTATING GROOMER
1. LH support plate
2. Bearing
3. Seal
4. Plug
Figure 22
Seal lip
(toward center of
cutting unit)
3
2
4
1
1. Outer bearing
2. Drive plate shoulder
3. Inner bearing
4. Inner race
5. Seal lip
6. Support plate bearing
7. Drive plate (RH side)
8. Support plate (LH side)
Figure 23
1
2
3
4
5
5
5
6
7
8
Groomer
To Next Page
Loading...
