Greensmaster Flex 1800/1820/2100/2120Traction and Reel Drive System Page 4 − 50
Transmission
Figure 57
1. Transmission assembly
2. Flange head screw
3. Drum drive belt
4. Extension spring
5. Brake band
6. Drum drive cover
7. Washer head screw (11 used)
8. Retaining ring
9. Hardened washer
10. Cap screw
11. RH drum drive housing
12. Flange nut
13. Extension housing
FRONT
RIGHT
2
3
6
8
9
10
11
1
5
7
12
4
7
13
See text for
tightening
procedure
Transmission removal from the machine is not neces-
sary in order to service internal transmission compo-
nents. Transmission components can be accessed by
removing the engine from the frame, removing the
transmission cover and then removing the drive belt. If
transmission removal is desired, proceed with the fol-
lowing steps. Once the transmission has been removed
from the machine, service procedures for internal com-
ponents are described earlier in this section.
Transmission Removal
1. Park machine on a level surface. Make sure engine
is OFF.
2. Disconnect reel clutch cable from transmission (see
Reel Clutch Cable Replacement in the Service and Re-
pairs section of Chapter 6 − Chassis and Controls).
3. Disconnect traction clutch cable from transmission
(see Traction Clutch Cable Replacement in the Service
and Repairs section of Chapter 6 − Chassis and Con-
trols).
4. Slide the telescoping coupler off the cutting unit hex
shaft (Fig. 58).
5. Remove RH drum drive cover and belt from machine
(see Drum Drive Belt in this section).
To Next Page
Loading...
