Greensmaster Flex 1800/1820/2100/2120 Page 7 − 5 Cutting Unit
Special Tools
Some special tools may have been supplied with your
mower or are available as TORO parts. Order special
tools from your Toro Distributor. Some tools may also be
available from a local supplier.
Gauge Bar Assembly
Toro Part Number: 13−8199
Used to verify height−of−cut.
Figure 5
Backlapping Brush Assembly
Toro Part Number: TOR299100
Used to apply lapping compound to cutting unit while
keeping the operator’s hands at a safe distance from the
rotating reel.
Components for the brush assembly are available indi-
vidually as follows:
Brush 36−4310
Handle 29−9080
Handle cap 2410−18
Figure 6
Bedknife Screw Tool
Toro Part Number: TOR510880
This screwdriver−type bit is made to fit Toro bedknife at-
taching screws. Use this bit with a 3/8” drive torque
wrench to secure the bedknife to the bedbar.
DO NOT use an air or manual impact wrench with this
tool.
Figure 7
Cutting Unit
To Next Page
Loading...
