Greensmaster Flex 1800/1820/2100/2120 Traction and Reel Drive SystemPage 4 − 3
General Information
Operator’s Manuals
The Traction Unit and Cutting Unit Operator’s Manuals
provide information regarding the operation, general
maintenance and maintenance intervals for your
Greensmaster machine. Refer to these Operator’s
Manuals for additional information when servicing the
machine.
Disengaging Drum Drive From Transmission
The traction drum is driven by a multi−ribbed belt that is
tensioned with a spring loaded idler assembly. To disen-
gage the traction drum drive from the transmission, fol-
low the following procedure:
1. Park machine on a level surface. Make sure engine
is OFF. Remove spark plug wire from the engine spark
plug.
2. Locate the traction engage/disengage lever next to
the RH drive housing drum (Fig. 1).
CAUTION
Be careful when rotating the traction engage/dis-
engage lever. The lever is spring loaded and may
cause personal injury. Push lever from the front
when removing belt tension to prevent unex-
pected movement of the lever.
3. Rotate traction engage/disengage lever toward the
rear of the machine to the disengaged position to re-
move tension from the drum drive belt.
4. To engage the drum drive, rotate traction engage/
disengage lever to the engaged position by rotating the
lever toward the front of the machine.
5. Connect spark plug wire to spark plug.
1. Engaged position 2. Disengaged position
Figure 1
2
1
Traction and Reel
Drive System
To Next Page
Loading...
