Greensmaster Flex 1800/1820/2100/2120 Traction and Reel Drive SystemPage 4 − 9
Transmission Clutch Adjustment (1820/2120)
1. Clutch cable
2. Cable bracket
3. Clutch lever
4. Clutch lever pin
5. Extension spring
6. Clevis pin
7. Spring anchor
Figure 13
1
2
3
4
5
6
7
2.5” (63.5 mm)
2.875” to 3.000”
(73 to 76 mm)
1. The traction clutch cable must be installed to clutch
lever on transmission and lever assembly on handle of
machine.
2. Adjust cable nuts at cable bracket on transmission to
remove slack in cable without extending the extension
spring (up to 0.030” (0.8 mm) slack is permissible). The
distance from the cable bracket to the clutch lever pin
center should be 2.5” (63.5 mm) when the clutch lever
is disengaged.
3. Adjust spring anchor on transmission actuator pin to
obtain a distance from the clutch lever pin center to the
spring anchor clevis pin center from 2.875” to 3.000” (73
to 76 mm) when the clutch lever is engaged. After ad-
justment of spring anchor, use a wrench to hold spring
anchor and tighten jam nut with second wrench.
4. Make sure that clutch has proper level of multi−pur-
pose ATF before returning the machine to operation
(see the machine Operator’s Manual).
Traction and Reel
Drive System
To Next Page
Loading...
