Greensmaster 3300/3400 Page 2 -- 1 Product Records and Maintenance
Chapter 2
Product Records and Maintenance
Table of Contents
PRODUCT RECORDS 1.........................
MAINTENANCE 1...............................
EQUIVALENTS AND CONVERSIONS 2...........
Decimal and Millimeter Equivalents 2............
U.S. to Metric Conversions 2...................
TORQUE SPECIFICATIONS 3....................
Fastener Identification 3.......................
Using a Torque Wrench with an Offset Wrench 3..
Standard Torque for Dry, Zinc Plated and
Steel Fasteners (Inch Series). 4...............
Standard Torque for Dry, Zinc Plated and
Steel Fasteners (Metric Fasteners). 5..........
Other Torque Specifications 6..................
Conversion Factors 6..........................
Product Records
Inserta copyof theTraction UnitandCuttingUnitOper-
ator’s Manuals and Parts Catalog for your Greensmas-
terat theendofthischapter. Additionally,if anyoptional
equipment or accessories have been installed to your
machine, insert the Installation Instructions, Operator’s
ManualsandPartsCatalogsforthoseoptionsattheend
of this chapter.
Maintenance
Maintenanceproceduresandrecommendedservicein-
tervals for your Greensmaster are covered in the Trac-
tion Unit Operator’s Manual. Maintenance procedures
andrecommendedserviceintervalsfortheGreensmas-
ter Cutting Units are covered in the Cutting Unit Opera-
tor’s Manual. Refer to these publications when
performing regular equipment maintenance. Refer to
theEngineOperator’sManualforadditionalenginespe-
cific maintenance procedures.
Product Records
and Maintenance
To Next Page
Loading...
