Greensmaster 3300/3400Page 6 -- 10Electrical System
Clearing Fault Codes
After fault codes have been retrieved, clearing of those
faults can be completed using the following switch se-
quence:
1. Place machine switches in fault retrieval (see
above). The diagnostic light should be displaying the
fault codes.
2. Operator seat should remain UNOCCUPIED.
3. Move backlap valve on mow control manifold to the
BACKLAP position.
4. Move joystick to the RAISE position.
5. Monitor the diagnostic light for continuous flashing
indicatingthatallfaultshavebeenclearedfromthecon-
troller memory.
To Next Page
Loading...
