Greensmaster 3300/3400 Page 6 -- 47 Electrical System
Turf Guardian
TM
Leak Detector Alarm (If Equipped)
NOTE: Greensmaster 3300 machines are equipped
with the Turf Guardian
TM
Leak Detector System. On
Greensmaster 3400 machines, the Leak Detector Sys-
tem is optional.
Machines equipped with the Turf Guardian
TM
Leak De-
tectorSystemincludeanalarmthatsoundsifahydraulic
leakis detectedby thesystem.The alarmis attachedto
the outside of the control console assembly.
Testing
1. Park machine on level surface, lower cutting units,
stop engine, apply parking brake and remove key from
ignition switch.
2. Remove console cover from console assembly to
gainaccesstoalarm(seeControlConsoleDisassembly
intheServiceand Repairssectionof Chapter7 -- Chas-
sis).
IMPORTANT: Make sure to observe polarity on the
alarm terminals when testing. Damage to the alarm
may result from an improper connection.
3. Disconnectwireharnessconnectorfromalarm.Cor-
rectly connect 12VDC source to the alarm terminals
(Fig. 62). Alarm should sound.
4. Remove voltage source from the alarm. Replace
alarm if necessary. Connect wire harness connector to
alarm.
5. Install console cover (see Control Console Assem-
bly in the Service and Repairs section of Chapter 7 --
Chassis).
1. Top view
2. Bottom view
3. Positive (+) terminal
4. Negative (--) terminal
Figure 62
3
2
4
1
Electrical
System
To Next Page
Loading...
