Toro Greensmaster TriFlex 3400 - Page 247

Greensmaster 3300/3400 Page 7 -- 1 7 Chassis
Disassembly (Fig. 12)
1. Parkmachineonalevelsurface,engagetheparking
brake, lower the cutting units and stop the engine. Re-
move key from the ignition switch.
2. Remove screws(item12) thatsecureconsolecover
(item2) toconsole.Lowercovertoallowaccesstocon-
sole components.
3. Remove componentsfrom controlc onsole asneed-
ed using Figure 12 as a guide.
4. Disassemble functional control lever assembly as
needed using Figure 13 as a guide.
5. Disassemble joystick assembly as needed using
Figure 14 as a guide.
NOTE: The alarm (item 15) is used on machines that
are equipped with the Turf Guardian
TM
Leak Detector
System.
NOTE: Referto Chapter6 -- ElectricalSystemfor infor-
mation regarding electrical components on console.
Assembly (Fig. 12)
1. If functional control lever assembly was disas-
sembled, assemble control lever using Figure 13 as a
guide.
2. If joystick assembly was disassembled, assemble
joystickusingFigure14asaguide.Iffingerspringwash-
ers (item 7 in Fig. 14) were removed, position washers
so that fingers on washer point towards pivot hub.
3. Install all removed components to control console
using Figure 12 as a guide.
4. Position console cover (item 2) to console and se-
cure with screws (item 12).
1. Console
2. Pivot tube
3. Functional lever
4. Split bushing
5. Cap screw
6. Flat washer
7. Lock nut
8. Roller pivot
9. Bushing
10. Flat washer
11. S pring spacer
12. Torsion spring
13. Flat washer
14. Lock nut
15. Bearing spacer (2 used)
16. Bearing
17. Lock nut
18. Spring pin
19. Ball joint
20. Neutral lock cable
21. Lock nut
22. Cable clamp
23. Neutral sensor
24. Knob
25. Mow sensor
26. Screw (2 used)
27. Screw (2 used)
28. Lock nut (2 used)
29. Clip (2 used)
30. Lever bracket
31. Jam nut (4 used)
32. Lock washer (4 used)
Figure 13
2
3
4
5
6
7
8
9
10
11
12
13
14
16
17
18
19
20
21
22
24
27
28
26
29
23
15
1
25
30
31
32
FRONT
1. Joystick rod
2. Jam nut
3. Joystick bracket
4. Switch (2 used)
5. Screw (2 per switch)
6. Spacer
7. Finger spring washer
8. Flat washer
9. Cap screw
10. Bushing
11. Pivot hub
12. Torsion spring
13. Speed nut (2 used)
14. Lock nut
Figure 14
2
3
6
8
9
10
11
13
1
5
7
12
14
4
7
10
Chassis