Greensmaster 3300 Page 3 -- 7 Gasoline Engine
Adjustments
Choke Cable Adjustment
1. Parkmachineonalevelsurface,disengageandlow-
er cutting units, move functional control lever to neutral
(N),engageparking brake,stopthe engineandremove
the key from the ignition switch. Wait for all machine
movement to stop.
2. Remove air cleaner cover and air filter from engine.
3. Move choke control on control panel while watching
choke plate in carburetor.
A. Choke plate should be fully open when choke
control is pushed in.
B. Choke plate should be fully closed when choke
control is pulled out.
4. Ifcableadjustmentisneeded,loosencapscrewand
nut that secure choke cable clamp. R eposition cable to
allow correct choke operation. Secure choke c able
clamp.
5. After adjustment, move choke control several times
to make sure that choke operation is correct.
6. Assemble air cleaner.
Throttle Cable Adjustment
1. Parkmachineonalevelsurface,disengageandlow-
er cutting units, move functional control lever to neutral
(N),engageparking brake,stopthe engineandremove
the key from the ignition switch. Wait for all machine
movement to stop.
2. Adjustthrottlecontrol onconsoletothe fastposition.
Inspectgovernorleveronenginetomakesurethatlever
is fully rotated and against stop on governor control.
3. If throttle cable adjustment is needed (Fig. 2):
A. Loosen cap screw that secures throttle cable
clamp on engine bracket.
B. Reposition c able to allow correct governor rota-
tion.
C. Tighten screw to secure throttle cable clamp.
4. After adjustment, move throttle control on console
from low idle to high idle to make sure that cable travel
is correct.
Figure 2
1. Throttle cable
2. Cable clamp
3. Governor control lever
2
1
3
Gasoline
Engine
To Next Page
Loading...
