Toro Greensmaster TriFlex 3400 - Page 253

Greensmaster 3300/3400 Page 7 -- 2 3 Chassis
Removal (Fig. 18)
1. Parkmachineonalevelsurface,engagetheparking
brake, lower the cutting units and stop the engine. Re-
move key from the ignition switch.
2. Remove grass basket from suspension assembly.
3. Removecuttingunitfromsuspensionassembly(see
Traction Unit Operator’s Manual).
4. If front suspension assembly is to be removed, re-
move front wheel (see Wheel Removal in this section).
This willallow easier access to flangehead screws that
secure suspension assembly to frame.
5. Removehydraulichosebracketfromsuspensionas-
sembly (Fig. 19 or 20).
6. Position and support reel motor and attached hy-
draulic hoses away from suspension assembly.
CAUTION
Supportsuspension assembly whenremovingit
topreventitfromfallingandcausingpersonalin-
jury.Suspensionassemblyweighsapproximate-
ly 65 pounds (30 kg).
7. Support suspension assembly to prevent it from
shifting or falling.
8. Remove three (3) flange head screws (item 2) that
secure suspension assembly to machine frame. Re-
move suspension assembly from machine.
Installation (Fig. 18)
1. Make sure that all suspension components are cor-
rectly assembled.
2. Position suspension assembly to frame. Align
mounting holes and secure suspension with three (3)
flangeheadscrews(item2).Torquesscrews from55to
60 ft--lb (75 to 81 N--m).
3. Position reel motor and attached hydraulic hoses to
suspension assembly. Insert reel motor shaft into stor-
age location on front of suspension assembly.
4. Secure hydraulic hose bracket to suspension as-
sembly (Fig. 19 or 20). Torque two (2) socket head
screws from 85 to 115 in--lb (9.6 to 12.9 N--m).
5. Install cutting unit to suspension assembly (see
Traction Unit Operator’s Manual).
6. Install grass basket to suspension assembly.
1. Cap screw (4 used)
2. Strap (2 used)
3. Tube clamp (4 used)
4. Hose bracket
5. Flange nut (4 used)
6. Socket screw (2 used)
7. Case drain hose
8. Pressure hose
9. Return hose
Figure 19
5
3
2
4
1
3
6
9
8
7
FRONT CUTTING UNIT
85 to 115 in--lb
(9.6 to 12.9 N--m)
1. Screw (2 used)
2. Tube clamp (2 used)
3. Cap screw
4. R--clamp (2 used)
5. R--clamp
6. Hose bracket
7. Socket screw (2 used)
8. Cap screw
9. Pressure hose
10. Case drain hose
11. Return hose
Figure 20
9
10
11
6
2
7
8
4
3
5
1
CENTER CUTTING UNIT
85 to 115 in--lb
(9.6 to 12.9 N--m)
Chassis