Greensmaster 3300/3400
DPA Cutting Units
Page 8 -- 22
6. Install shoulder bolts (item 4) and flange nuts (item
5) to secure the LH side plates to the crossmember.
Torque the shoulder bolts from 210 to 240 in--lb (24 to
27 N--m).
7. Position crosslink to pitch arms and secure with
washer head screws ( item 3).
8. If bearing lock nut (RH threads) and reel nut (LH
threads) were loosened during cutting reel service, put
a block of wood between the cutting reel blades to pre-
vent the reel from rotating.Torque bearing lock nut (RH
threads) and reel nut (LH threads) from 90to110 ft--lb
(123 to 149 N--m) (Fig. 23).
9. Thoroughly fillsplineareaofreel nut(left sideof cut-
ting reel) with grease.
10.Secure the bedbar assembly to LH side plate (see
BedbarInstallation inthissection). Makesurethat plas-
tic and steel washers are properly positioned.
11.Secure front and rear rollers to LH side plate (see
Front Roller Installation and Rear Roller Installation in
this section).
12.Adjust cutting unit (see Cutting Unit Operator’s
Manual).
NOTE: The parallelpositionof therear rollerto thecut-
ting reel is controlled by the precision machined cross-
memberandsideplatesof thecuttingunit.Ifnecessary,
the cuttingunit side platescanbe loosenedanda slight
adjustment can be made to parallel the rear roller with
the cutting reel(see Leveling Rear Rollerinthe Set--Up
and Adjustments section of this Chapter).
13.Install newO--ring (item12) on weight(item 10).Se-
cureweighttoRHsideplatewithtwo(2)capscrewsand
nuts.
14.If cutting unit is equipped with optional groomer or
rearrollerbrush,installcomponentsforthoseoptionsto
cuttingunit.SeeServiceandRepairssectionofChapter
9 -- Groomerforinformationongroomer.SeeRearRoll-
er Brush in this section for information on rear roller
brush.
15.Install cutting unit to the machine.
To Next Page
Loading...
