Toro Greensmaster TriFlex 3400 - Grooming Reel

Greensmaster 3300/3400Groomer Page 9 -- 14
Grooming Reel (Counter Rotating Groomer Drive)
Figure 10
1. RH groomer arm assembly
2. HOC nut (2 used)
3. Bushing (2 used)
4. Spring washer (2 used)
5. Lock nut (2 used)
6. LH groomer arm assembly
7. Cap screw (2 used)
8. Grooming reel assembly
9. HOC washer (2 used)
10. HOC screw (2 used)
11. O--ring
12. RH drive plate assembly
13. Shoulder bolt (2 used)
14. Driven gear (30T)
15. Lock nut
16. Front roller
17. Groomer drive gear (45T)
18. Bearing (2 used)
19. RH cutting unit side plate
20. Gasket
21. Flange head screw (5 used)
22. Groomer cover assembly
23. 47T idler gear
24. Flange nut (2 used)
25. Extension spring
26. Inner spring (2 used)
27. Outer spring (2 used)
28. LH support plate assembly
29. Support plate
30. Button head screw (4 used)
31. Plow bolt (2 used)
32. LH cutting unit side plate
33. 43T idler gear
33
1
3
4
5
6
7
9
10
12
13
14
15
17
18
20
21
22
23
24
25
26
27
28
29
30
31
32
7
13
18
24
9
10
2
2
8
16
11
19
125 ft--lb
(170 N--m)
120 in--lb
(13.5 N--m)
120 in--lb
(13.5 N--m)
17 to 21 ft--lb
(23 to 28 N--m)
Antiseize
Lubricant
31
Remove the groom ing reel to replace individualblades,
to replace worn groomer components, to reverse the
bladesontheshaft(ifnotequippedwithcarbideblades)
or to replace the grooming shaft.
Removal (Fig. 10)
1. Park machine on a clean, level surface. Lower cut-
tingunitscompletelytotheground,stopengine,engage
parking brake and remove key from the ignition switch.
2. Remove thecutting unitfrom themachine andplace
cutting unit on a flat work area.
3. Make sure that handle on groomer cover is rotated
toward front o f machine so that groomer drive is en-
gaged.
4. Removegroomercoverassembly(item22)andgas-
ket(item20)frommachine(seeGroomerCover(Count-
er Rotating Groomer Drive) in this section). Discard
gasket.
5. Carefully remove extension spring from anchor
points on RH drive plate (Fig. 11).
6. Remove the two (2) idler gears (43T and 47T) from
the RHdrive plateassembly (Fig.12). Thebearingsare
pressed into the gears.
7. Loosen cap screws (item 7) that secure front roller
shaft to groomer arms.