Greensmaster 3300/3400 GroomerPage 9 -- 15
8. Remove lock nut a nd spring washer that secure RH
groomerarmliftrodtoRHdriveplateassembly(Fig.13).
9. RemoveHOCnut(item2),HOCwasher( item9)and
plowbolt (item31)that secureRH groomerarmassem-
bly to RH drive plate assembly. Do not change height--
of--cut screw adjustment. Remove RH groomer arm
assembly from cutting unit.
10.Remove front roller from cutting unit.
NOTE: To prevent grooming reel shaft from turning
when removing driven gear (item 14), use wrench on
shaft flats to hold shaft.
11.Remove the lock nut (item 15) that secures driven
gear (item 14) to grooming reel shaft. Remove driven
gear from shaft.
NOTE: To prevent cutting reel from turning when re-
moving groomer drive gear (item 17), block reel with
piece of wood.
12.Loosen and remove groomer drive gear (item 17)
from the cutting reel shaft.
13.Remove four (4) button head screws (item 30) that
securetheRHdriveplatea ssembly(item12)tothesup-
port plate on the cutting unit frame. Remove the RH
drive plate assembly from grooming shaft and cutting
unit.
14.Carefully pull the grooming reel assembly from the
LH support plate.
15.Inspect seals, bushings and bearings in RH drive
plate, LH support plate and groomer arms for wear or
damage. Also, inspect gears and idler components for
wear or damage. Replace components as needed.
Installation (Fig. 10)
1. Apply a light coating of grease to ends of grooming
reel shaft and also to seal lips in RH drive plate and LH
supportplate.Makesurethatallbearings,bushingsand
seals are properly installed.
2. Make sure that O--ring (item 11) is installed on
grooming reel shaft. Apply light coating of grease to O--
ring.
3. Carefully place grooming reel assembly into the LH
support plate taking care to not damage seal in support
plate or O--ring on shaft.
4. Apply light coating of grease to O--ring on RH drive
plate assembly pivot hub and pilot bore of cutting unit
side plate.
1. Extension spring
2. 43T idler gear
3. 47T idler gear
4. Groomer drive gear
Figure 11
4
2
1
3
1. RH drive plate assy
2. Flange nut
3. 43T gear/bearing
4. 47T gear/bearing
Figure 12
3
1
2
4
120 in--lb
(13.5 N--m)
1. Roller cap screw
2. Grooming reel assembly
3. Lock nut
4. Spring washer
5. Groomer arm lift rod
Figure 13
4
2
1
3
5
Groomer
To Next Page
Loading...
