Toro Greensmaster TriFlex 3400 - Page 309

Greensmaster 3300/3400 GroomerPage 9 -- 19
2. Install LH support plate to left side of cutting unit:
A. Applyantiseizelubricant tothreads ofLHgroom-
er arm lift rod.
B. Position support plate to cutting unitmaking sure
that LH groomer arm lift rod is positioned through
bushing in support plate.
C. Place spring washer and lock nut on lift rod
threads (Fig. 19). Tighten lock nut.
D. Position motor mount to groomer support plate
(Fig. 18). Secure motor mount and support plate to
cutting unitwithtwo(2)socket headscrews andlock
nuts.
3. Install grooming r eel, front roller and RH drive plate
to cuttingunit(seeGrooming Reel (Forward Rotating or
Counter Rotating) in this section).
4. Check and adjust grooming reel height and mower
height--of--cut settings.
5. Install cutting unit to the machine.
6. Lubricate groomer bearings.
NOTE: After greasing groomer bearings, operate
groomerfor30seconds,stopmachineandwipeanyex-
cess grease from groomer shaft and seals.
1. RH drive plate assy
2. Bearing (2 used)
3. Seal (2 used)
Figure 21
3
1
2
2
3
Seal lips
(toward center of
cutting unit)
COUNTER ROTATING GROOMER
1. LH support plate
2. Bearing
3. Seal
4. Plug
Figure 22
Seal lip
(toward center of
cutting unit)
3
2
4
1
1. Outer bearing
2. Drive plate shoulder
3. Inner bearing
4. Inner race
5. Seal lip
6. Support plate bearing
7. Drive plate (RH side)
8. Support plate (LH side)
Figure 23
1
2
3
4
5
5
5
6
7
8
Groomer