Toro Greensmaster TriFlex 3400 - Page 315

Greensmaster 3300/3400 GroomerPage 9 -- 25
Disassembly (Fig. 30)
1. Remove flange nut (item 2) that secures lift arm to
HOC groomer arm. Remove lock nut (item 16) and
springwasher(item17)thatsecurelift armtosideplate.
Loosen lock screw (item 6) completely.
2. Remove flange nut (item 2) that secures lift arm as-
semblytoHOCgroomerarm.Removelocknut(item16)
and spring washer (item 17) that secure lift arm as-
sembly to side plate. Loosen lock screw (item 6) com-
pletely.
3. Remove lift arm assembly from cutting unit.
4. Disassemble lift arm using F igure 30 as a guide.
NOTE: Right and left side HOC groomer arms (item 1)
andliftarmassemblies(item8)aredifferent;othercom-
ponentsshown in Figure30 are thesame on bothsides
of cutting unit.
NOTE: Groovedpin(item3)isusedtoretainlockscrew
(item 6) to lift arm assembly.
Assembly (Fig. 30)
1. Assemble lift arm using Figure 30 as a guide.
2. Apply antiseize lubricant to threads of groomer lift
rod (item 5) and lift arm assembly stud (item 8).
3. Installliftarmassemblyontocuttingunit.Securewith
flange nut (item 2) and lock nut (item 16) with spring
washer (item 17).
4. Secure groomer in raised or lowered position with
lock screw (item 6).
5. Check and adjust grooming reel height and mower
height--of--cut settings.
Groomer