Toro Greensmaster TriFlex 3400 - Groomer Brush

Greensmaster 3300/3400Groomer Page 9 -- 26
Groomer Brush
Figure 31
1. Groomer brush shaft
2. Lock nut
3. J--bolt
4. Groomer brush
5. O--ring
20 to 25 in--lb
(2.3 to 2.8 N--m)
20 to 25 in--lb
(2.3 to 2.8 N--m)
3
1
2
4
2
3
5
The groomer brush attaches to the groomer drive in
place of the grooming reel. Removal and installation of
thegroomerbrushusesthesameprocedureasremoval
and installation of the grooming reel (see Grooming
Reel in this section).
Toremovethegroomerbrushfromtheshaft,removethe
locknutandJ--boltfrombothendsofthebrushandslide
the brush fromtheshaft. Whenassembling the brushto
the shaft, secure the assembly with J--bolts and lock
nuts. Make sure that the J--bolts are installed with the
threaded portion on the outside of the brush (Fig. 32).
Torque lock nuts from 20 to 25 in--lb (2.3 to 2.8 N--m).
1. J--bolt 2. Lock nut
Figure 32
2
1