Greensmaster 3400 Page 4 -- 15 Diesel Engine
2. Close fuel shut--off valve on fuel tank.
3. Remove air cleaner and air intake hose from ma-
chine (see Air Cleaner Removal in this s ection).
4. Remove radiator from machine (see Radiator Re-
moval in this section).
5. Remove exhaust system from machine (see Ex-
haust System Removal in this section).
6. Disconnect fuel supply hose from the injector pump
and fuel return hose from the #3 injector. Drain any fuel
trapped in the hoses into a suitable container. Remove
hoses from grommets in engine support on front of en-
gine. Plug hoses and position them away from engine
assembly.
7. Loosenscrewthatsecuresthethrottlecabletoswiv-
el on injector pump speed control lever. Disconnect
cable from swivel and cable bracket (Fig. 10). Position
cable away from engine.
8. Disconnect wire harness c onnectors from engine
components:
NOTE: Beforedisconnectingwireharnessconnectors,
label all electrical leads for assembly purposes.
A. Negative battery cable and wire harness ground
from lower engine mount fastener (Fig. 11).
B. Fuel stop solenoid (Fig. 12).
C. Glow plug bus (Fig. 12).
D. Temperature sender (Fig. 12).
E. Alternator connector and stud (Fig. 13).
F. Starter motor solenoid and fusible link harness
(Fig. 13).
G. Oil pressure switch (near oil filter) ( Fig. 13).
CAUTION
Support the hydraulic pump assembly when re-
moving its supporting fasteners to prevent it
from falling and causing damage or personal in-
jury.
9. Support hydraulic pump assembly to prevent it from
moving during engine removal.
10.Removetwo(2)capscrewsandflatwashersthatse-
cure hydraulic pump assembly to bell housing on en-
gine.
Figure 10
1. Throttle cable
2. Speed control lever
3. Cable jam nut
4. Throttle cable swivel
4
2
1
3
Figure 11
1. Engine mount
2. Negative cable
3. Wire harness ground
3
2
1
Figure 12
1. Fuel return hose
2. Throttle cable swivel
3. Fuel stop solenoid
4. Glow plug bus
5. Temperature sender
1
4
5
2
3
Diesel
Engine
To Next Page
Loading...
